Differences from Rev. 12xV4.0F.
1. The LED chains are now connected between X1 and X2. As a result, the LED assemblies can be easily connected in series. This simplifies the assembly of a LED fixture, especially when using our 2x LED drivers with a high voltage power supply: up to 5 LED assemblies can be connected in series.
2. The cool white channel has been split into two chains of 3 LEDs each. This helps to simplify the series connection of LED assemblies.
3. An MCPCB with improved thermal path has been used. The LEDs can now be used at their maximum current.
of chain of
|Max. current||Max. voltage
on the chain
|LED emitter type|
|Cool White||X1 pin1 -> X2 pin6||1000ma||10.8V||CCT:8300-10000K||Semileds C35L-W0-A,130-148lm @ 350mA, 3pcs|
|Blue||X1 pin2 ->
|1000ma||3.6V||460-470nm||Semileds C35L-BN-A, 30.6-35.2lm @ 350mA|
|Turquois||X1 pin3 ->
|1000ma||3.6V||510-520nm||Semileds C35L-CN-A, 73.9-80.6lm @ 350mA|
|Neutral White||X1 pin4 ->
|1000ma||10.8V||CCT:3700-4300K||Semileds C35L-W1-A, 130-139lm @ 350mA, 3pcs|
|Red||X1 pin5 ->
|700ma||2.8V||620-630nm||Semileds C35L-R, 51.7lm up @ 350mA|
|Cool White||X1 pin6 -> X2 pin1||1000ma||10.8V||CCT:8300-10000K||Semileds C35L-W0-A,130-148lm @ 350mA, 3pcs|
|Total power consumption, W: ||up to 39|
|Length, mm / in||70 / 2.77|
|Width, mm / in||60 / 2.37|
|Height, mm / in||7.4 / 0.29|
|Mounting holes diameter, mm / in||3.3 / 0.13|
|Mounting holes spacing, mm / in||47.5 / 1.88|
|Weight, grams / oz||33 / 1.16|
|Completely solderless assembly. Matching connectors are included.||YES|
The LED assembly must be used with matching LED drivers. If using with ReedLedLab controller and drivers, control channels on the drivers can be configured by jumpers. Instructions.
“*” No competing solutions were available on the market by April, 2014
Use our Spectrum Simulator to evaluate the spectral output of the LED assembly in different modes:
The spectral graphs are based on mathematical simulation and are provided for reference only.
Make a DIY LED fixture using our LED assembly: Video Tutorial:
Note: – the tutorial was made using rev. 2.2 of the 6-channel LED assembly and a different connector. You can also watch our video tutorial on how to use the new connectors.
Using the KRP crimper tool: