This product is obsolete and will not be available any longer. It is replaced by version 4.1F
The information on this page is provided for reference purposes.
|Color||Max. current||Max. voltage drop on the chain||Wavelength /
|LED emitter type|
|Power connector X1|
|Blue||1000ma||3.6V||460-470nm||Semileds C35L-BN-A, 30.6-35.2lm @ 350mA|
|Cool White||1000ma||21.6V||CCT:8300-10000K||Semileds C35L-W0-A,122-130lm @ 350mA, 6pcs|
|Power connector X2|
|Turquois||1000ma||3.6V||510-520nm||Semileds C35L-CN-A, 73.9-80.6lm @ 350mA|
|Red||700ma||2.8V||620-630nm||Semileds C35L-R, 51.7lm up @ 350mA|
|Neutral White||1000ma||10.8V||CCT:3700-4300K||Semileds C35L-W1-A, 122-130lm @ 350mA, 3pcs|
|Total power consumption, W: ||up to 39|
|Length, mm / in||70 / 2.77|
|Width, mm / in||60 / 2.37|
|Height, mm / in||7.4 / 0.29|
|Mounting holes diameter, mm / in||3.3 / 0.13|
|Mounting holes spacing, mm / in||47.5 / 1.88|
|Weight, grams / oz||33 / 1.16|
|Completely solderless assembly. Matching connectors are included.||YES|
The LED assembly must be used with matching LED drivers. If using with ReedLedLab controller and drivers, control channels on the drivers can be configured by jumpers. Instructions.
“*” No competing solutions were available on the market by January, 2014
This assembly is built on the universal MCPCB; two installed chains of three white diodes are integrated into itt. Pay your attention to the connector color code:
The Red (plus) and grey (minus) wire is power supply of the integrated chain of white diodes, and the blue (minus) and yellow(plus) is for the blue LED.
Passive cooling is not recommended at currents above 700mA.
Use our Spectrum Simulator to evaluate the spectral output of the LED assembly in different modes:
The spectral graphs are based on mathematical simulation and are provided for reference only.
Make a DIY LED fixture using our LED assembly: Video Tutorial:
Note: – the tutorial was made using rev. 2.2 of the 6-channel LED assembly and a different connector. You can also watch our video tutorial on how to use the new connectors.
Using the KRP crimper tool: