|At the moment there aren’t even remote analogues of the BEAMS-R v1 LED assemblies which could be compared to them combining these main characteristics:|
|- the number of LED control channels. There are 7 in this assembly.|
|- the density of the installation of LEDs. This assembly contains 9 LEDs which optical centers do not extend beyond a circle with a diameter of 8 mm.|
|- the type of LEDs used. This assembly is the first one to use the ultra-compact Flip Chip LEDs developed by Lumileds. Luxeon C colour LEDs are widely used, which are especially designed for luminaires with adjustable spectrum. The latest TSLC2016 LEDs are also used.|
|- the thermal conductivity of the material of the printed circuit board (PCB). Thermal conductivity of the special Polytronics material is approximately 8 times higher than that of inexpensive metal plates|
|Maximum power consumption, W::||22|
|Recommended power consumption*, W:||13|
|The length of LED assembly, mm||30|
|The width of LED assembly, mm||40|
|The height of LED assembly, mm||4,2|
|Diameter of the mounting holes, mm||3,3|
|Distance between the centres of the mounting holes, mm||26|
|Connection without soldering||yes|
|Lifetime of LED assembly until the amount of radiation reaches 70% of the original, hours**||>100K|
*To achieve the best price/performance ratio. Also, this mode of use is recommended when using a heat sink with passive cooling.
**Being part of the BEAMS system, following the terms of usage and for the temperature of LED crystals no more than 70° C and current not more than 70% of maximum.
*** Similar solutions are not yet available on the market, as of January 2018
1.Open the connector retainer by pulling it out by its edge connector:
The effort required for this is very little, please do not use a lot of force to avoid breaking the lock
2. Place the flexible ribbon cable with its contacts facing up. Insert it into the ZIF connector until it stops. This is done with small effort.
Then, simultaneously press on the edges of the retainer, using the back of the ZIF connector until it stops.
Push the lock into the connector until it stops.
The required force is not big. Please apply the same force to both edges of the retainer not allowing it to skew.
3. The properly closed lock of the ZIF connector looks like this:
Pay attention - the gap between the retainer edges and the body of the connector is completely absent.
Please note that if the ED assemblies are placed correctly the inscription BEAMS V1.0 and inductors is at the bottom.
|Color||Max. current||Max. voltage
on the chain
|LED emitter type|
|Violet||1000ma||3.3V||405-410nm||LUXEON UV L1F2-U400100007001|
|Royal blue||1000ma||3.1V||455-460nm||LUXEON FlipChip Royal Blue L0F2-B455100005501, 3pcs|
|Blue||1000ma||3.3V||475-480nm||Luxeon C BLU1000000000, E40|
|Turquoise||1000ma||2.9V||496-500nm||Luxeon C L1C1-CYN1000000000, L20|
|Mint||1000ma||3V||-*||Luxeon C L1C1-MNT1000000000, Flux bin V|
|PC Amber||1000ma||3.6V||-*||TSLC 2016M T2016M-ZZZ 50lm up@350mA|
|Red||700ma||2.4V||620-630nm||TSLC 2016M T2016M-RNN1 30lm up@350mA|