Shopping
Cart




2х LED driver assembly V1.2
 
Version 1.2 Product code: 2xV1.2


 
  $16.00

Availability:  Out of Stock

This product is obsolete and will not be available any longer. The information is provided for reference purposes. Please use instead of it the new version
Number of independent drivers 2
Number of channels in dimmer control bus* 9
Drivers supply voltage range** 6V ... 56V
Maximum output current, ma*** 700, 1000
Dimming resolution (number of steps) up to 2000
Output current range 0.5 to 1000мА            
Efficiency, up to 96%
Board dimensions:  
             Length, mm / in     65 / 2.56
            Width, mm / in 46 / 1.81
            Height, mm / in 12.7 / 0.50
Mounting holes diameter, mm / in 3.3 / 0.13
Mounting holes spacing, mm / in 57x38 / 2.25x1.50
Weight, grams / oz 30 / 1.05
Completely solderless assembly. Matching connectors are included. YES
 
“*” jumper-select any 2 channels of 9
“**” driver’s supply voltage must be higher than the required output voltage (determined by the number and type of LEDs connected in chain)
“***” maximum current is set by a jumper, separately for each driver

Connectors and pinouts


 

X1 Power connector
IMPORTANT: PAY ATTENTION TO POLARITY, AS INDICATED ON THE PCB.

WRONG POLARITY WOULD DAMAGE THE DRIVER ASSEMBLY
 
X2 PWM inputs connector

Pinout:
Pin Description
1 Signal ground
2 Channel 9 input
3 Channel 8 input
4 Channel 7 input
5 Channel 6 input
6 Channel 5 input
7 Channel 4 input
8 Channel 3 input
9 Channel 2 input
10 Channel 1 input
 
SW1-SW2 Jumpers for driver control channel selection. SW1 selects control channel (1..9) for driver 1, SW2 - for driver 2.
 
1XI-2XI Three-pin connectors to select corresponding drivers' maximum output current. Set the jumper to position marked 0.7 for 700ma, or to position 1.0 for 1000ma.
 
XL LEDs connector. 
IMPORTANT: PAY ATTENTION TO POLARITY, AS INDICATED ON THE PCB. WRONG POLARITY MAY DAMAGE THE LEDs.

 

Features:

  • Simple, solderless assembly, minimizes time and effort spent for building a fixture
  • Over-current and over-temperature protection
  • Silent operation
  • High efficiency
  • Low  profile
  • Small dimensions
  • High reliability components extended operation life
  • Up to 24 LEDs can be connected to each driver (depending on type)
  • Flat bottom side (can be mounted with double-side adhesive tape)
  • 100% quality control
     

 


 

Make a DIY LED fixture using our LED assembly: Video Tutorial:

Note: – the tutorial was made using rev. 2.2 of the 6-channel LED assembly and a different connector. You can also watch our video tutorial on how to use the new connectors.

Using the KRP crimper tool:

Theoretical and practical aspects of LED lighting

What type of light is available to corals in nature? What type of light do corals require for growth and for best coloration? Under what spectrum will your reef tank look its best? You will find the answers to these questions in this section.

All you need for DIY

Do you want to build a DIY LED fixture that would best fit your tank’s requirements, using the state of the art technological achievements and the highest grade components? You will find the answers to these questions in this section.

FAQ

Building a DIY LED fixture has never been so easy! Find the answers to many questions that hundreds of others have asked. Everything you want to know about building DIY LED fixtures is available in this section.