Driver assembly is improved version of this driver assembly, that received a such improvements:
- Push-in connectors, no necessity in special cables. Strip the end of cable on 5-7mm, press the button on connector, insert cable and release button. Connector will clamp cable.
- Improved performance.
- Drivers is noiseless for relative any PWM modes.
|Number of independent drivers||2|
|Number of channels in dimmer control bus*||9|
|Drivers supply voltage range**||6V ... 56V|
|Maximum output current, ma***||700, 1000|
|Dimming resolution (number of steps)||up to 2000|
|Output current range||0.5 to 1000мА|
|Efficiency, up to||97%|
|Length, mm / in||65 / 2.56|
|Width, mm / in||46 / 1.81|
|Height, mm / in||12.7 / 0.50|
|Mounting holes diameter, mm / in||3.3 / 0.13|
|Mounting holes spacing, mm / in||57x38 / 2.25x1.50|
|Weight, grams / oz||30 / 1.05|
|Completely solderless assembly. Matching connectors are included.||YES|
|“*”||jumper-select any 2 channels of 9|
|“**”||driver’s supply voltage must be higher than the required output voltage (determined by the number and type of LEDs connected in chain)|
|“***”||maximum current is set by a jumper, separately for each driver|
Connectors and pinouts
IMPORTANT: PAY ATTENTION TO POLARITY, AS INDICATED ON THE PCB.
WRONG POLARITY WOULD DAMAGE THE DRIVER ASSEMBLY
|X2||PWM inputs connector|
|2||Channel 9 input|
|3||Channel 8 input|
|4||Channel 7 input|
|5||Channel 6 input|
|6||Channel 5 input|
|7||Channel 4 input|
|8||Channel 3 input|
|9||Channel 2 input|
|10||Channel 1 input|
|SW1-SW2||Jumpers for driver control channel selection. SW1 selects control channel (1..9) for driver 1, SW2 - for driver 2.
|1XI-2XI||Three-pin connectors to select corresponding drivers' maximum output current. Set the jumper to position marked 0.7 for 700ma, or to position 1.0 for 1000ma.
IMPORTANT: PAY ATTENTION TO POLARITY, AS INDICATED ON THE PCB. WRONG POLARITY MAY DAMAGE THE LEDs.
Make a DIY LED fixture using our LED assembly: Video Tutorial:
Note: – the tutorial was made using rev. 2.2 of the 6-channel LED assembly and a different connector. You can also watch our video tutorial on how to use the new connectors.
Using the KRP crimper tool: